A novel model for curriculum design: Preparation, planning, prototyping, and piloting.

Dental education continuously strives to provide students with positive and meaningful learning experiences. Developing or improving a curriculum usually encompasses three main phases: design, implementation, and evaluation. Most research on curriculum development in dental education has focused on the last two phases. Our commentary addresses this gap by describing a new model for curriculum design that effectively guided the design phase of the complete overhaul of the four-year Doctor of Dental Surgery curriculum at the School of Dentistry, University of Alberta. Built on the strengths of pre-existing curriculum design models, the new model provided enough structure and rigour to support the complexity required during a complete curriculum redesign whilst still allowing sufficient consultation and flexibility to encourage stakeholder engagement. The steps of the new 4P's model (preparation, planning, prototyping, and piloting) and main actions within each step are described. Challenges observed in each step and strategies to address them are reported. Other institutions embarking on renewing or redesigning a curriculum at a program level may benefit from using a curriculum design process similar to the 4P's model. Recommendations are discussed including the inclusion of educational consultants in the curriculum renewal committee, the importance of a leadership that effectively supports curriculum reform, purposeful engagement of stakeholders during each step of the design phase and ensuring that project and change management occur concurrently.