Evaluation of Radicular Dentin Thickness in Maxillary and Mandibular Central Incisor, Canine, and Premolar Teeth.

Background This study aimed to compare the radicular dentin thickness in single-rooted maxillary and mandibular anterior and premolar teeth by measuring on four different surfaces (buccal, lingual, mesial, and distal) at three different levels (apical, middle, and coronal). Methods A total of 150 single-rooted human anterior and premolar teeth were included in the present study. The teeth were sectioned at the cemento-enamel junction (CEJ; coronal), 4 mm away from the apex (apical), and the midpoint between these two distances (middle). First, the teeth were divided buccolingually into two parts, and the dentin thickness in the mesial/distal region was measured. Subsequently, both parts were divided again to measure the dentin thickness in the buccal/lingual region. All measurements were recorded, and statistical analysis was performed. Results Apical radicular dentin thickness was significantly less than CEJ (p < 0.001). The maxillary central incisor, maxillary, and mandibular canine exhibited the maximum radicular dentin thickness, whereas the mandibular premolars showed the minimum. Radicular dentin thicknesses on the lingual and buccal surfaces were significantly higher than those on other surfaces (p < 0.001). Conclusion The lowest radicular dentin thickness values were observed in the premolars, especially on mesial and distal surfaces. Considering these areas as danger zones and paying attention during dental procedures are essential to avoid possible complications.