Piezoresistive Porous Composites with Triply Periodic Minimal Surface Structures Prepared by Self-Resistance Electric Heating and 3D Printing.

Three-dimensional flexible piezoresistive porous sensors are of interest in health diagnosis and wearable devices. In this study, conductive porous sensors with complex triply periodic minimal surface (TPMS) structures were fabricated using the 3D printed sacrificial mold and enhancement of MWCNTs. A new curing routine by the self-resistance electric heating was implemented. The porous sensors were designed with different pore sizes and unit cell types of the TPMS (Diamond (D), Gyroid (G), and I-WP (I)). The impact of pore characteristics and the hybrid fabrication technique on the compressive properties and piezoresistive response of the developed porous sensors was studied. The results indicate that the porous sensors cured by the self-resistance electric heating could render a uniform temperature distribution in the composites and reduce the voids in the walls, exhibiting a higher elastic modulus and a better piezoresistive response. Among these specimens, the specimen with the D-based structure cured by self-resistance electric heating showed the highest responsive strain (61%), with a corresponding resistance response value of 0.97, which increased by 10.26% compared to the specimen heated by the external heat sources. This study provides a new perspective on design and fabrication of porous materials with piezoresistive functionalities, particularly in the realm of flexible and portable piezoresistive sensors.