We have located links that may give you full text access.
Effectiveness of high irradiance for short-time exposures on polymerization of composite under metal brackets.
Angle Orthodontist 2017 November
OBJECTIVE: To evaluate the effect of different curing modes available in a dental light-curing unit on degree of conversion (DC) of a composite photoactivated under a metal orthodontic bracket.
MATERIALS AND METHODS: The average irradiance and total energy delivered by three curing modes (standard, high, and extra power) of a multiwave LED unit (Valo Cordless, Ultradent Products, South Jordan, Utah) were measured using the longest time available for each mode (20, 4, and 3 seconds, respectively). Brackets (n = 3/group) were bonded to molar epoxy resin replicas using each curing mode. Mesiodistal sections, 0.5 mm thick, were assessed using an infrared spectrometer microscope. Spectra of composite beneath the brackets were sequentially collected using the mapping tool in near-infrared (NIR)-transmittance mode. Composite conversion was mapped between the mesial and distal edges of the bracket base using 400-μm steps for a total of 10 measurements per specimen. Data from irradiance and total energy were analyzed by one-way ANOVA, while data of DC were analyzed with two-way repeated measures ANOVA (α = 0.05).
RESULTS: The highest DC values were observed for standard power (mean 56%, P < .05), while no difference was observed between high (50%) and extra power (49%) modes. Regarding the site of measurement, higher DC was observed close to the bracket edges (52%, P < .05).
CONCLUSIONS: The use of high irradiance for a short time slightly reduced the DC. The small magnitude of reduction suggests that use of a high irradiance protocol is a clinically valid approach when bonding metal brackets.
MATERIALS AND METHODS: The average irradiance and total energy delivered by three curing modes (standard, high, and extra power) of a multiwave LED unit (Valo Cordless, Ultradent Products, South Jordan, Utah) were measured using the longest time available for each mode (20, 4, and 3 seconds, respectively). Brackets (n = 3/group) were bonded to molar epoxy resin replicas using each curing mode. Mesiodistal sections, 0.5 mm thick, were assessed using an infrared spectrometer microscope. Spectra of composite beneath the brackets were sequentially collected using the mapping tool in near-infrared (NIR)-transmittance mode. Composite conversion was mapped between the mesial and distal edges of the bracket base using 400-μm steps for a total of 10 measurements per specimen. Data from irradiance and total energy were analyzed by one-way ANOVA, while data of DC were analyzed with two-way repeated measures ANOVA (α = 0.05).
RESULTS: The highest DC values were observed for standard power (mean 56%, P < .05), while no difference was observed between high (50%) and extra power (49%) modes. Regarding the site of measurement, higher DC was observed close to the bracket edges (52%, P < .05).
CONCLUSIONS: The use of high irradiance for a short time slightly reduced the DC. The small magnitude of reduction suggests that use of a high irradiance protocol is a clinically valid approach when bonding metal brackets.
Full text links
Related Resources
Get seemless 1-tap access through your institution/university
For the best experience, use the Read mobile app
All material on this website is protected by copyright, Copyright © 1994-2024 by WebMD LLC.
This website also contains material copyrighted by 3rd parties.
By using this service, you agree to our terms of use and privacy policy.
Your Privacy Choices 
You can now claim free CME credits for this literature searchClaim now
Get seemless 1-tap access through your institution/university
For the best experience, use the Read mobile app