Prediction of particle deposition around the cabin air supply nozzles of commercial airplanes using measured in-cabin particle emission rates.

Enhanced soiling on the surfaces around air supply nozzles due to particle deposition is frequently observed in commercial airliners. The problem is worsened by severe outdoor air pollution and flight delays in China. The particles in an aircraft cabin originate from both outdoor and in-cabin sources. This study conducted measurements on multiple commercial flights to obtain particle emission rates from in-cabin sources. Additional experiments on a retired MD-82 airplane provided justification of the in-flight measurements. The in-cabin sources emitted more particles during boarding/deplaning than during meal servicing and sitting. The average PM2.5 emission rates were 7.2, 2.6, 1.9, and 1.8 (μg/min per person), respectively, during the boarding/deplaning, sitting on the ground, sitting in the air, and meal servicing. The corresponding PM10 emission rates were 15.4, 6.1, 5.3, and 5.4 (μg/min per person), respectively, for these four periods. The average particle emission rate from in-cabin sources varied seasonally and was the highest in winter. With the measured data, this investigation used a CFD model to predict the accumulation of particles deposited around the nozzles of an airplane, taking into account the flight routes and the outdoor particle concentrations at the airports where the airplanes were parked. For the most polluted airplane in China, the dirty spots/areas around the nozzles inside the airplane became visible after 6 months. The method proposed in this study can be used for any commercial airplane to predict the accumulation of particles deposited around the air supply nozzles.