Investigating the Effect of Bioirrigation on In Situ Porewater Concentrations and Fluxes of Polychlorinated Biphenyls Using Passive Samplers.

Polychlorinated biphenyl (PCB) fluxes from contaminated sediments can be caused by mechanisms including diffusion, bioirrigation, and resuspension, but it is often unclear which mechanisms are important. In the Lower Duwamish Waterway (Seattle, Washington), the presence of abundant benthic macrofauna suggests that porewater bioirrigation may be an important mechanism for PCB transport from the bed into the overlying water column. In this field study, the fluxes of PCBs due to bioirrigation were quantified by using (a) polyethylene (PE) samplers to quantify in situ and ex situ (i.e., equilibrium) PCB porewater concentration profiles and (b) measurements of the geochemical tracer 222 Rn to quantify the rate of porewater exchange with overlying water. The results showed that bioirrigation caused sorptive disequilibrium with the surrounding sediment, which led to lower in situ porewater concentrations than expected from sediment concentrations. The combined fluxes of seven PCB congeners (Σ7 PCBs) were 1.6-26 ng/m2 /day for the three field sites, similar in magnitude to the upper limit estimates of diffusive fluxes calculated assuming water-side boundary layer control (Σ7 PCBs = 1.3-47 ng/m2 /day). Moreover, the depleted in situ porewater concentrations imply lower diffusive flux estimates than if the ex situ porewater concentrations had been used to estimate fluxes (Σ7 PCBs = 89-670 ng/m2 /day). These results suggest that nondiffusive PCB fluxes from the sediment bed are occurring and that quantifying in situ porewater concentrations is crucial for accurately quantifying both diffusive and nondiffusive PCB fluxes.