Oxygen isotope analysis of levoglucosan, a tracer of wood burning, in experimental and ambient aerosol samples.

RATIONALE: Levoglucosan is formed from cellulose during biomass burning. It is therefore often used as a specific tracer to quantify the contribution of wood burning to the aerosol loading. The stable oxygen isotope composition (δ18 O value) of biomass is determined by the water cycle and varies regionally, and hence the δ18 O value of levoglucosan could help to identify source regions of organic aerosols.

METHODS: After solvent extraction of the organic fraction and concentration steps, a recently developed methylation derivatisation technique was applied on experimental (i.e. controlled wood-burning experiments) and on ambient aerosol samples from Switzerland and Lithuania. The method achieves sufficient compound separation for isotope analysis in atmospheric particulate matter, enabling δ18 O analysis of levoglucosan by gas chromatography/pyrolysis-isotope ratio mass spectrometry (GC/Pyr-IRMS), with a precision better than 1.0 ‰ and an accuracy of 0.3 ‰.

RESULTS: The δ18 O value of the levoglucosan released during controlled wood-burning experiments was not significantly different from the cellulose δ18 O values, which implies very little or no isotope fractionation during wood burning under the given conditions. While the δ18 O values of levoglucosan in Swiss samples were as expected for the source region, those in Lithuania were 1-4 ‰ lower than expected. This may be due to differences in vegetation (grass vs wood) or burning conditions (high vs low temperatures).

CONCLUSIONS: Low oxygen isotope fractionation between cellulose and levoglucosan and clear differences in levoglucosan δ18 O values between the Swiss and Lithuanian ambient samples demonstrate that our new method is useful for source appointment studies on wood-burning-derived aerosols.