Retentive Strength of Y-TZP Crowns: Comparison of Different Silica Coating Methods on the Intaglio Surfaces.

OBJECTIVE: To evaluate the effect of different methods of silica deposition on the intaglio surface of yttrium oxide stabilized zirconia polycrystal (Y-TZP) crowns on the retentive strength of the crowns.

METHODS: One hundred simplified full-crown preparations produced from fiber-reinforced polymer material were scanned, and 100 Y-TZP crowns with occlusal retentions were milled. Crown/preparation assemblies were randomly allocated into five groups (n=20) according to the treatment of the intaglio surfaces: TBS = tribochemical silica coating via air-abrasion with 30-μm silica-coated alumina particles; GHF1 = application of thin glaze layer + hydrofluoric acid (HF) etching for 1 minute; GHF5 = glaze application + HF for 5 minutes; GHF15 = glaze application + HF for 15 minutes; NANO = silica nanofilm deposition (5 nm) via magnetron sputtering. All groups received a silane application. The surfaces of the preparations (polymer) were conditioned with 10% HF for 30 seconds and silanized. The crowns were cemented with resin cement, thermocycled (12,000 cycles; 5°C/55°C), stored for 60 days, and subjected to a retentive strength test (0.5 mm/min until failure). The retention data (MPa) were analyzed using one-way analysis of variance, Tukey tests, and Weibull analysis. Failures were classified as 50C (above 50% of cement in the crown) and 50S (above 50% of cement on the substrate).

RESULTS: The TBS (5.6±1.7 MPa) and NANO groups (5.5±1 MPa) had higher retentive strength than the other groups (p<0.0001) and had the highest values of characteristic strength. There was no difference in Weibull modulus, except for the GHF1 group (lower values). The TBS and GHF15 groups, respectively, had 60% and 70% of their failures classified as 50C, while most of the other groups had 50S failures.

CONCLUSION: Tribochemical silica coating and silica nanofilm deposition on the inner surface of zirconia crowns promoted a higher retentive strength.