Bulk-fill resin composites: polymerization properties and extended light curing.

OBJECTIVES: The aim was to evaluate the polymerization properties of bulk-fill resin composites using two different light-curing protocols, in terms of degree of conversion (%DC), Vickers hardness (HV), polymerization volume shrinkage (PVS) and polymerization shrinkage stress (PSS) and compare them to conventional condensable and flowable resin composites.

MATERIALS AND METHODS: Filtek BulkFill (FBF, 3MESPE, Germany), SDR (Dentsply, Germany), TetricEvoCeram BulkFill (TBF, Ivoclar-Vivadent, Liechtenstein), Venus BulkFill (VBF, Heraeus, Germany), X-traBase (XTB, Voco, Germany), FiltekZ250 (3MESPE) and Filtek Supreme XTE Flowable (FSF, 3MESPE) were investigated. Light-curing was performed for 30 s or according to manufacturers' instructions (1200 mW/cm2, Bluephase20i, Ivoclar-Vivadent). For %DC and HV, discs (n=5) of 2 or 4 mm in thickness were prepared and stored for 24h in distilled water at 37°C. %DC was determined by FTIR-ATR-spectroscopy. %DC and HV were measured at the top and bottom of the specimens. PVS was measured using Archimedes method (n=6). PSS measurements (n=10) were carried out using 5 mm diameter PMMA rods as bonding substrates with a specimen height of 1 mm in a universal testing machine. Data were analyzed using one- and two-way ANOVA (α=0.05).

RESULTS: Except Z250 in the manufacturers' light-curing mode, all materials showed no significant inferior %DC at 4 mm thickness. When light cured for 30 s Z250 had no significant differences in %DC at 2 or 4 mm when compared to top. FBF, TBF, FSF and Z250 displayed significant reduced HV at 4 mm in both curing modes. Z250 and TBF showed the lowest PVS and FSF the highest PSS in both curing modes.

SIGNIFICANCE: All investigated bulk-fill composites obtained sufficient polymerization properties at 4 mm depth. Enhanced curing time improved the investigated polymerization properties of bulk-fills and Z250.