Sinus lift complication

The purpose of this study was to evaluate clinical and radiologic outcomes using a newly developed device for maxillary sinus membrane elevation. Patients with a residual bone height of at least 3 mm were enrolled. Crestal sinus lift elevation and sinus graft were performed using the crestal approach sinus (CAS) kit. Graft was avoided if the residual bone crest was ≤ 2 mm less than the length of the planned implant. Outcome measures were implant and prosthesis failure, any biologic or technical complications, and marginal bone loss (MBL)...

INTRODUCTION: Recently, a rational design of the window osteotomy, the "Low Window" technique, was proposed to facilitate sinus augmentation and reduce postsurgical patient discomfort; this article aims to evaluate its safety and effectiveness. MATERIALS AND METHODS: Records were assessed retrospectively for patients who had sinus lifts using the low window approach, followed by implant placement and prosthetic rehabilitation. Outcomes analyzed were implant and prosthetic success and survival rates and rate of complications...

The demand for facial feminization is increasing in transsexual patients. Masculine foreheads present extensive supraorbital bossing with a more acute glabellar angle, whereas female foreheads show softer features. The aim of this article is to describe our surgical technique for fronto-orbital feminization. The mask-lift technique is an upper face-lift. It provides rejuvenation by correcting collapsed features, and fronto-orbital feminization through burring of orbital rims and lateral canthopexies. Depending on the size of the frontal sinus and the thickness of its anterior wall, frontal remodeling is achieved using simple burring or by means of the eggshell technique...

This case describes the successful long-term outcome of a patient's treatment after a restorative failure occurred soon after delivery. The esthetic and restorative treatment has been successful for nearly a decade due largely to a careful, objective evaluation of all possible causes of the restorative failure. The treatment plan for the patient, who was assessed as high risk biomechanically and functionally, was carried out in the following phases: (1) an implant placement that required an osteotome sinus lift; (2) placement of feldspathic bonded veneers for the maxillary anterior teeth to minimize removal of tooth structure; (3) numerous core-supported restorations, with fixed partial dentures placed for teeth Nos...

PURPOSE: In the presence of severe sinus mucosal thickening, the ostium can be blocked when the sinus membrane is lifted, causing drainage disturbances and sinusitis. Here, we present 3 cases in which maxillary sinus floor elevation was performed using a crestal approach in the presence of severe sinus mucosal thickening (>10 mm). MATERIALS AND METHODS: The effects of maxillary sinus floor elevation using the crestal approach technique on sinus mucosal thickening and bone formation in the sinus were evaluated using cone beam computed tomography...

Background and aim: Given the importance of evaluating the maxillary sinus lateral wall thickness (LWT) to avoid complications during surgery, the aim of this study was to examine LWT as well as the effect of residual ridge height (RH), edentulous region, type of edentulism, age and gender on it. Methods: In this cross-sectional study conducted in 2016, 150 samples of the CBCT imaging archives of the Oral and Maxillofacial Radiology Clinic in Babol, Iran, were evaluated retrospectively...

PURPOSE: To evaluate whether 5.0 × 5.0 mm dental implants with a novel nanostructured calcium-incorporated titanium surface could be an alternative to implants of at least 10.0 mm long placed in bone augmented with bone substitutes in posterior atrophic jaws. MATERIALS AND METHODS: Forty patients with atrophic posterior (premolar and molar areas) mandibles with 5.0 mm to 7.0 mm bone height above the mandibular canal, and 40 patients with atrophic maxillas with 4...

PURPOSE: To evaluate whether 4.0 mm short dental implants could be an alternative to augmentation with xenographs in the maxilla and placement of at least 10.0 mm long implants in posterior atrophic jaws. MATERIALS AND METHODS: A group of 40 patients with atrophic posterior (premolar and molar areas) mandibles with 5.0 mm to 6.0 mm bone height above the mandibular canal and 40 patients with atrophic maxillas having 4.0 mm to 5.0 mm below the maxillary sinus, were randomised according to a parallel group design to receive between one and three 4...

BACKGROUND: Until now, sinus floor elevation represents the gold standard procedure in the atrophic maxilla in order to facilitate dental implant insertion. Although the procedure remains highly predictive, the perforation of the Schneiderian membrane might compromise the stability of the augmented bone and implant success due to chronic sinus infection. The aim of this retrospective cohort study was to show that a membrane tear, if detected and surgically properly addressed, has no influence on the survival of dental implants and bone resorption in the augmented area...

BACKGROUND This study aimed to assess treatment outcomes of the cleft lift procedure and V-Y flap technique in the treatment of recurrent pilonidal sinus disease (PSD). MATERIAL AND METHODS A total of 51 patients who underwent cleft lift procedure and 43 patients who underwent fasciocutaneous V-Y flap technique were evaluated. The demographic characteristics, previous operations, duration of symptoms, perioperative complications, duration of operation and hospital stay, duration of draining of all patients, and recurrence of PSD were recorded...

Background: The traditional approach for reduction of frontal sinus fractures is coronal incision. Inherent complications of the coronal approach include long scar, hair loss, and long operation time. We describe a simple approach for the reduction of frontal sinus anterior wall fractures using a suprabrow incision that is commonly used for brow lift. Methods: From March 2007 to October 2016, the authors identified patients with anterior wall frontal sinus fractures treated by open reduction through a suprabrow incision...

Pneumatization of the sinus is a common occurrence after extraction of maxillary posterior teeth. Implant procedures require a clinically acceptable level of bone to be present for implants to be placed in function. Residual bone with >4 mm of height can be managed using the indirect sinus lift procedure, whereas bone height <4 mm requires a direct sinus lift using lateral window approach. This clinical case report describes the use of autogenous core used to lift the membrane in conjunction with calcium phosphosilicate putty using minimal armamentarium, thereby avoiding the associated morbidity and complications associated with a direct sinus lift procedure...

PURPOSE: To compare the outcome of implants inserted in maxillary sinuses augmented with anorganic bovine bone (ABB) grafts vs mixed 50% ABB and 50% autologous bone graft, using a lateral window approach. MATERIALS AND METHODS: This study was designed as a randomised controlled trial of parallel groups. Patients in need of an implant-supported prosthesis in a maxillary posterior area with a residual alveolar bone height no greater than 4 mm (range 0-4 mm) were recruited for lateral sinus grafting...

PURPOSE: To evaluate the efficacy of short (5 or 6 mm long) dental implants vs 10 mm or longer implants placed in crestally lifted sinuses. MATERIALS AND METHODS: Twenty partially edentulous patients with 5 to 7 mm of residual crestal height and at least 7 mm thickness below the maxillary sinuses as measured on computed tomography scans were randomised according to a parallel group design to receive either one to two 5 or 6 mm long implants (10 patients) or 10 mm long implants (10 patients) after crestal sinus lifting and grafting with anorganic bovine bone...

Our purpose was to evaluate the occurrence of complications and the degree of bone loss in a cohort of patients treated with fixed prostheses supported by immediately loaded dental implants. The primary aim was to compare partial versus full-arch fixed dental prostheses. We then tested the effect of sinus lifting. In the present retrospective cohort study, the patients had their implants restored with fixed dental prostheses supported by dental implants positioned in the posterior maxilla and mandible. When necessary, the maxillary sinuses were grafted with particulate autogenous bone...

OBJECTIVE: To evaluate the effectiveness and clinical results of a new crestal sinus lift technique used to elevate the sinus floor simultaneously with bone grafts and implant placement. METHODS: Eleven patients underwent this crestal sinus lift technique performed using an SCA KIT. The mean residual bone height was 6.4 mm (range: 4.1 mm to 8.6 mm). Bio-Oss collagen was used as the graft material, and 12 implants were simultaneously placed after sinus augmentation...

OBJECTIVE: To improve the confidence of the final year dental students in completing occlusal and oral rehabilitation of patients, with complexities beyond their scope, based on full analysis of the biomechanical and esthetic considerations of each case. MATERIAL & METHODS: Two comprehensive patient situations presenting with special difficulties including extensive, reduced vertical dimension of occlusion, limited interocclusal space and maxillary alveolar bone for implant insertion necessitating bone augmentation and a sinus lift surgery was managed by two students at our institute...

PURPOSE: To evaluate the clinical and radiographic outcomes of a one-stage crestal sinus elevation procedure using a self-tapping endosseous implant system (iRaise, Maxillent, Herzliya, Israel) developed for sinus augmentation, 1 year after loading. MATERIALS AND METHODS: Patients needing restoration in the posterior maxilla with a residual alveolar crest of 3 to 8 mm in height and 5 mm in width distal to the canine as measured on CBCT scan were treated using the iRaise sinus lift system...

OBJECTIVES: To determine a paradigm for evaluating and managing maxillary sinus conditions before dental implantation via preoperative sinonasal assessment. STUDY DESIGN: Prospective cohort study. METHODS: Eighty-four patients who underwent dental implantation with or without sinus augmentation were included. Maxillary sinus conditions were classified into groups 1 to 6 according to cone-beam computed tomography (CT) findings: 1) nonspecific findings, 2) solitary polyp or cyst, 3) mucosal thickening, 4) air-fluid level or fluid accumulation, 5) near-total opacification of the maxillary or other paranasal sinus, and 6) calcification spots in the maxillary sinus...

The posterior maxilla is challenged with postextraction alveolar bone resorption and pneumatization drive of the Schneiderian membrane that reduces the subantral distance. To overcome such anatomic obstacle a sinus augmentation procedure was introduced either via lateral or crestal approach depending on residual ridge height. The current study evaluated oxidized regenerated cellulose (ORC) as a grafting material versus osteon II by measuring bone gain and graft density, 24 weeks postoperatively. Twenty consecutive patients (24 cases) aged from 20 to 65 years were considered eligible after clinical and radiographic evaluation...