Applied Radiation and Isotopes

This study aimed to investigate the effect of diabetes on radiation attenuation parameters of the femur and tibia of rats using Monte Carlo Simulations. First, control and diabetic rats were identified and tibias and femurs were removed. Then, the elemental ratios of the bones obtained were calculated using EDS (Energy Dissipative X-ray Spectroscopy). Therefore, radiation permeability properties of control and diabetic bones were simulated by using the content ratios in the bones in MCNP6 (Monte Carlo N-Particle) and PHITS (Particle and Heavy Ion Transport code System) 3...

At CERN-ISOLDE, high-purity radioactive ion beams of 219 Fr and 221 RaF were investigated with α-decay spectroscopy at the CRIS and ASET experiments in the course of three different experimental campaigns. The half-life of 215 At, α-decay daughter of 219 Fr, is measured to be 36.3(3)[9]μs, and that of 221 Ra was determined to be 26.2(1)[6]s, both of which are well in line with the trends in this region of the nuclear landscape but at odds with some of the reported literature.

We present an investigation of the interpad region (IP) in the Ultra-Fast Silicon Detector (UFSD) Type 10, utilizing a femtosecond laser and the transient current technique (TCT). We elucidate the isolation structure and measure the IP distance between pads, comparing it to the nominal value provided by the vendor. A comparison of sensors with identical layouts but different nominal IP distances (49 μm vs. 61 μm) and different processing parameters revealed their significant different charge collection properties in the IP...

The article reports the production yields of the medically relevant Ru radionuclides and other co-produced radionuclides from 6,7 Li-induced reactions on 93 Nb target within the 20-45 MeV energy range. The residues were measured employing the activation technique followed by the offline γ-spectroscopy. Statistical model calculations using EMPIRE3.2.2 code are employed to assess the optimized nuclear model parameters and production mechanisms of the residues. As an outcome, new data from 6 Li reaction suggests 9720 MBq/C of thick target yield (TTY) for the production of 95 Ru with minimal impurities...

Dried figs were studied by Electron Paramagnetic Resonance (EPR) spectroscopy for identification of radiation treatment and dosage assessment. Gamma-irradiated samples show a multicomponent "sugar-like" EPR spectrum with line width of 6-8 mT, centered at g = 2.004. The investigation of the influence of the instrumental parameters microwave power and modulation amplitude on the EPR signal show saturation effect at microwave power above 2 mW and over modulation at modulation amplitude above 0...

Bruce Power operates a first-of-its-kind isotope production system (IPS) that enables continuous production of 177 Lu within Canada Deuterium Uranium (CANDU) commercial power reactors. Located on the reactivity mechanisms deck of Unit 7, just outside of reactor containment but in close proximity to the primary heat transport (PHT) pumps, this facility offers unique advantages for 177 Lu production. However, employees working in this area encounter a radiation hazard which consists primarily of photoneutrons...

A retrospective analysis of occupational exposure to ionizing radiation from medical uses and industrial uses in the three provinces of Central China from 2000 to 2021 was conducted. The average annual effective dose in medical uses and industrial uses decreased from 2.042 mSv and 2.334 mSv in 2000-2002 to 0.476 mSv and 0.371 mSv in 2021 respectively; the fraction of monitored workers receiving annual dose not exceeding 1 mSv increased from 60.78% and 74.45% in 2000-2002 to 94.20% and 96...

This paper introduces the KRISS-Rn4, a high-sensitivity radon monitor with four detection cells, installed within a walk-in type radon calibration chamber at KRISS. The KRISS-Rn4 exhibits enhanced energy resolution through channel-by-channel signal processing and data acquisition. Results reveal that it achieves lower statistical fluctuations and faster response times in monitoring test atmospheres compared to commercial devices.

In the present study, a facile nano-sized gamma alumina was synthesized and then examined for immobilization of cobalt and cesium ions individually from aqueous solutions. The comprehensive analysis of functional groups, phase composition, surface morphology and sorption characteristics of the synthesized nano-sized ϒ alumina was executed. It was deduced that acquired material was low-crystalline with a high elimination efficacy towards the concerned cations under slightly alkali and acidic conditions...

Natural antimony targets were irradiated in a 60 MeV bremsstrahlung beam and gamma spectrometric measurements were performed. The goal was to establish the yield of 117m Sn, a radionuclide with great potential for application in medicine. Considering that 117m Sn is predominantly produced through a photonuclear reaction in which an charged particle is emitted (121 Sb(γ,p3n)), the yield of this tin isotope is much lower than the yields of several antimony isotopes produced in (γ,xn) reactions...

In decision making, e.g. conformity to a specification like a reference value or a requirement, the decision rule applied shall be documented. Furthermore, if the measurement uncertainty is considered in the decision process the associated probability, or risk, that a measurement result is above (or below) a reference value shall be taken into account. In this work it is shown that for gross alpha and gross beta measurements the evaluation method, GUMUF (GUM Uncertainty Framework) or MC (Monte Carlo), may also be important and influence the decisions taken when measurement results are very close to the reference value...

The absence of genetic variability among crop genotypes is an impediment to breeding progress, hence mutagenesis could serve as a useful tool to create genetic variation to obtain desirable traits of interest. In this study, four maize genotypes, Obatampa, Dapango, Pann 54 and Honampa which were susceptible to maize streak disease (MSD) were acutely irradiated at 254.3 Gy, using a cobalt 60 (60 Co) at a rate of 300 Gy/hr. The irradiated seeds were planted with their parental controls at streak disease highly endemic environment...

The goal of this work was to develop a reliable method to produce the well-validated microglial activation PET tracer, [18 F]DPA-714, routinely for clinical and preclinical research using an IBA Synthera®. Optimization of literature methods included reduced precursor mass and use of TBA HCO3 as the phase transfer agent in place of Kryptofix® 222 in a 65-min synthesis with an average activity yield of 24.6 ± 3.8% (n = 5). Successful quality control testing and process validation results are reported...

Cross sections of the 54 Fe(n,p)54 Mn, 54 Fe(n,α)51 Cr, 56 Fe(n,p)56 Mn and 204 Pb (n,2n)203 Pb reactions induced by D-T neutrons were obtained with activation method and γ-ray spectrometry technique. Experimental values measured in this work are consistent with most of the previous literature data. These reactions cross sections were theoretically calculated by using the TALYS-1.96 and EMPIRE-3.2.3 codes from threshold up to 20 MeV, and significant discrepancies were found between calculated results and experiment data...

Brazil is the fourth largest cement consumer in the world and the largest producer in Latin America, around 1.3% of global production. The main inputs in the manufacture of cement are limestone and clay. Few studies have been carried out in the country on the risk of these materials used in civil construction. Therefore, the objective of this present work is to evaluate the radiological danger that they can present to society. Gamma spectrometry analysis on 16 samples of different brands of cement used as construction material in Rio de Janeiro (Brazil) was performed in this study, using an HPGe detector and the Genie 2000 data acquisition software...

Accurate measurements of photonuclear reaction cross sections are crucial for a number of applications, including radiation shielding design, absorbed dose calculations, reactor physics and engineering, nuclear safeguard and inspection, astrophysics, and nuclear medicine. Primarily motivated by the study of the production of selected radionuclides with high-energy photon beams (mainly 225 Ac, 47 Sc, and 67 Cu), we have established a methodology for the measurement of photonuclear reaction cross sections with the microtron accelerator available at the Swiss Federal Institute of Metrology (METAS)...

Ensuring the integrity, safety, and compliance of oil pipelines is crucial for operators. Two significant factors affecting pipeline integrity are metal loss due to corrosion or air gouging and the presence of cracks. This paper introduces an X-ray backscatter nondestructive testing model on a smart pig(an intelligent robot) for internal inspection of petroleum pipelines. The paper investigates the X-ray source and detection system, essential components of the backscatter imaging technology, to provide technical guidance for model design...

Based on a developed analytical model, a method is proposed for measuring the photonuclear cross section averaged over bremsstrahlung flux without application of additional target-monitor of photon flux. The method involves the use of a thin isotopic target, that completely overlaps the photon beam (a photonuclear converter), as well as an algorithm for processing the data on the yield of a reaction under study in such a target. The novel technique was validated on the reactions 100 Mo(γ,n)99 Mo and 58 Ni(γ,n)57 Ni in the range of photon end-point energy of 40...

3D printing technology has rapidly spread for decades, allowing the fabrication of medical implants and human phantoms and revolutionizing healthcare. The objective of this study is to evaluate some radiological properties of commercially available 3D printing materials as potential tissue mimicking materials. Among fifteen materials, we compared their properties with nine human tissues. In all materials and tissues, exposure and energy absorption buildup factors were calculated for photon energies between 0...

The present study investigated the sorption behavior of 85 Sr and 60 Co radionuclides from aqueous solutions onto tin molybdate (SnMo) sorbent. SnMo has been synthesized using the precipitation method and was characterized using four analytical techniques including FT-IR, XRD, SEM, and XRF. The sorption studies applied on 85 Sr and 60 Co include the effect of shaking time, pH, concentration, and saturation capacity. The experimental data revealed that the sorption process was carried out after equilibrium time (180 min)...